[News]

News: Glomation introduced new wireless ready low cost GESBC-9260S

[SteveMartins]

SteveMartins

SteveMartins

Show SteveMartins's last posts.

Show general stats for SteveMartins.

• 
• Super Hero
• Posts: 27

hi,

I have built a new kernel for the 9260, but seem to be missing some support for MTD. I have the NAND driver, so it shows:

NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bit)
AT91 NAND: 8-bit, net ECC
Scanning device for bad blocks

but i should expect tha to be followed by:

3 cmdlinepart partitions found on MTD device at91_nand
Creating 3 MTD partitions on "at91_nand":
0x00000000-0x00100000 : "bootloader"
0x00100000-0x00400000 : "kernel"
0x00400000-0x08000000 : "rootfs"

which is missing. Am i missing a configuration setting? could someone point me in the right direction? I am building with at91sam9260ek_defconfig and just a single change for AT91NAND flash support.

thanks

Steve

[admin]

admin

admin

Show admin's last posts.

Show general stats for admin.

• 
• Administrator
• Super Hero
• Posts: 342

The MTD support must be enabled.   Attached is factory default config for GESBC-9260.  Copy it to kernel root directory as .config, make oldconfig, and do menuconfig to add customization.

[dann]

dann

dann

Show dann's last posts.

Show general stats for dann.

• 
• Super Hero
• Posts: 13

Hello,

I'd like to rebuild the kernel but I don't know which options need to be configured for using wireless. May you add the .config file with wireless configuration?

Regards,