[News]

News: Glomation introduces new GECM-9G25 SODIMM system on module

[ujar]

ujar

ujar

Show ujar's last posts.

Show general stats for ujar.

• 
• Super Hero
• Posts: 6

Hello,

I have new GESBC-9620S and have connected Hyperterminal via a null modem cable to the default DB9 female connector on the board. Even after say 10 minutes I see no prompt. Is this normal behavior? I would assume there is a linux prompt?

I have powered up the board with a 5V supply and see a LED glow on the board. Also I have put in a CR1220 button cell for the RTC.

I am using a belkin DB9 female to female cable to connect to my desk top which has a serial port.

Thanks,

ujar

[admin]

admin

admin

Show admin's last posts.

Show general stats for admin.

• 
• Administrator
• Super Hero
• Posts: 342

The debug UART on GESBC-9260(S) is P0.  The DB9 connector on the GESBC-9260S board is P1.  It is not enabled by the factory installed Linux file system.  Please connect the NULL modem cable to P0.